System Requirements: Difference between revisions
No edit summary |
No edit summary |
||
| Line 21: | Line 21: | ||
===Digital Pulser/Receivers=== | ===Digital Pulser/Receivers=== | ||
The JSR Control Panel program by [http://jsrultrasonics.com JSR Ultrasonics] is also useful for testing JSR pulser/receivers. | The JSR Control Panel program by [http://jsrultrasonics.com JSR Ultrasonics] is also useful for testing JSR pulser/receivers. | ||
===Other=== | ===Other=== | ||
Revision as of 16:44, 2 January 2024
Computer
- Windows 7/8/10/11 (64-bit)
- At least 8 GB of memory
- 100 GB or larger HD (recommended)
- Monitor with 1920x1200 resolution recommended
Drivers
Acquisition
For OKOS Digitizer support, AL.NET4 Acquisition Logic A/D board drivers must be installed.
When using Olympus FocusPX devices, the latest OpenView software must be installed. The Firmware packages used will depend on the installation.
Motion Control
For Motor controller support, GalilTools version 4 or above if using Galil motor controllers.
Note: Nippon Commander motor controllers are self-contained within the program and do not require special drivers. However, it is recommended that the latest firmware be loaded into the controller.
Digital Pulser/Receivers
The JSR Control Panel program by JSR Ultrasonics is also useful for testing JSR pulser/receivers.
Other
A non-expired Token file is also required for most ODIS software to run.
Hardware
For Acquisition and/or scanning, the following hardware is required:
- One or more A/D boards
- One or more Pulser/Receivers
- One or more Ultrasonic transducers
- One or more Motor Controllers
See Also: Supported Hardware