System Requirements

Computer

• Windows 7/8/10/11 (64-bit)
• At least 8 GB of memory
• 100 GB or larger HD (recommended)
• Monitor with 1920x1200 resolution recommended

Drivers

Acquisition

For OKOS Digitizer support, AL.NET4 Acquisition Logic A/D board drivers must be installed.

When using Olympus FocusPX devices, the latest OpenView software must be installed. The Firmware packages used will depend on the installation.

Motion Control

For Galil Motor controller support, GalilTools version 4 or above is useful for testing Motion Control.

For NPA Commander motor controllers, it is recommended that the latest firmware be loaded into the controller. The NPA Commander Core control software is useful for testing Motion Control.

Digital Pulser/Receivers

The JSR Control Panel program by JSR Ultrasonics is also useful for testing JSR pulser/receivers.

Other

A non-expired Token file is also required for most ODIS software to run.

Hardware

For Acquisition and/or scanning, the following hardware is required:

• One or more A/D boards
• One or more Pulser/Receivers
• One or more Ultrasonic transducers
• One or more Motor Controllers

See Also: Supported Hardware