System Requirements: Difference between revisions
No edit summary |
|||
| (2 intermediate revisions by the same user not shown) | |||
| Line 15: | Line 15: | ||
===Motion Control=== | ===Motion Control=== | ||
For Motor controller support, GalilTools version 4 or above | For Galil Motor controller support, GalilTools version 4 or above is useful for testing Motion Control. | ||
For NPA Commander motor controllers, it is recommended that the latest firmware be loaded into the controller. The NPA Commander Core control software is useful for testing Motion Control. | |||
===Digital Pulser/Receivers=== | ===Digital Pulser/Receivers=== | ||
Latest revision as of 16:48, 27 February 2025
Computer
- Windows 7/8/10/11 (64-bit)
- At least 8 GB of memory
- 100 GB or larger HD (recommended)
- Monitor with 1920x1200 resolution recommended
Drivers
Acquisition
For OKOS Digitizer support, AL.NET4 Acquisition Logic A/D board drivers must be installed.
When using Olympus FocusPX devices, the latest OpenView software must be installed. The Firmware packages used will depend on the installation.
Motion Control
For Galil Motor controller support, GalilTools version 4 or above is useful for testing Motion Control.
For NPA Commander motor controllers, it is recommended that the latest firmware be loaded into the controller. The NPA Commander Core control software is useful for testing Motion Control.
Digital Pulser/Receivers
The JSR Control Panel program by JSR Ultrasonics is also useful for testing JSR pulser/receivers.
Other
A non-expired Token file is also required for most ODIS software to run.
Hardware
For Acquisition and/or scanning, the following hardware is required:
- One or more A/D boards
- One or more Pulser/Receivers
- One or more Ultrasonic transducers
- One or more Motor Controllers
See Also: Supported Hardware