Search results

...peration of PVATePla-OKOS software, as well as providing information about configuration and maintenance. ===Software Components===

[[Category:Software Configuration]] ...mode, an operator cannot create or change parameter files or other system configuration files: they can only use them to run applications.

...ompare axis as a Servo axis (in newer boards, this is accomplished via the software)'' ===Motors.xml Configuration Settings===

[[Category:Software Configuration]] <p>Advanced Mode allows for complete control of all sub-sections of the ODIS software. It also has many more options for scanning, including [[Rotational Scan|R

==Rotational Scan Configuration== ...o be slower than for Linear scans, it is usually a good idea to turn off [[Configuration Settings#Instrumentation|Try to use Fast Downloading]] This prevents timeou

===Auto-Software=== ...n option [[Configuration Settings#Advanced Settings (Scanning)|"Always use Software Trigger when not scanning"]] must be disabled.</p>

<p>ODIS software should automatically detect all supported [[Glossary of Terms#A|A/D]] devic ...D. In [[Advanced Mode]], make sure you set your A/D Trigger mode to "Auto-Software", P/R Trigger mode to "External" and turn on the P/R. In [[Basic Mode]],

This section controls various configuration settings for [[Glossary of Terms#A|A/D]], [[Glossary of Terms#P|P/R]] and H ...checked, the digital oscilloscope will always be triggered by ODIS using a Software trigger when not in a scan, at a rate of approximately 20 times a second (t

Select whether to create a new ODIS_DATA folder, and/or copy configuration settings from the previous version.<br /> b) Make sure &quot;Copy Configuration&quot; is checked.<br>

AppSettings, i.e. Application Settings, is used for configuration information and to identify the [[Token File]] to be used to activate the p For software that uses the Olympus FocusPX, the following properties will be present:

*;Software Only [[File:ConfigFocusing.png|right|thumb|Focusing Configuration Tab]]

...n using ODIS in [[Advanced Mode]] or by using the stand alone Beam Profile software.'' ...he Water Velocity and Gate Tracking direction must be set correctly in the Configuration in order for the gates to follow the varying focus while the Z-axis. To co

[[Category:Software Configuration]] # The [[ODIS_Config.xml|system configuration]] ''Mode'' key must be set to ''basic''. This will load the Basic Mode as

<p>The Motors.xml file is used to define the motor axes used in most ODIS software. It is written to be a layer of abstraction above the motor controller its ...ag will contain a single [[#Axes|Axes]] tag as well as some board-specific configuration tags, listed below.

...he same as the application, e.g. if the application is "ODIS_NDT.exe", the configuration file will be called "ODIS_NDT.exe.config". The file is an XML file and can These keys are use for configuration of any A/D devices.